There was a bit of a misalignment of the cylinder head to the block that I fixed a while back, and it ended up screwing the alignment on quite a few different parts (cams, cylinders, crankshaft, connecting rods, pistons, bearing bridges... almost everything). Well, I finally got it all fixed I've also turned the 'camshaft bearing bridges' into proper camshaft bearing caps, and made the spark plug housings actually hollow so you can look through them at your pistons! I also added a 4A-GE inspired alternative cylinder head. I'd like to do another variation or two, but there doesn't seem to be many different designs IRL. I'm welcome to pretty much any and all suggestions ^^
I've also turned the 'camshaft bearing bridges' into proper camshaft bearing caps, and made the spark plug housings actually hollow so you can look through them at your pistons! I also added a 4A-GE inspired alternative cylinder head. I'd like to do another variation or two, but there doesn't seem to be many different designs IRL. I'm welcome to pretty much any and all suggestions ^^
