Author | Message |
PXRZ
Posts: 491
Location: Sweden Occupation: Proper fixin' up Age: V$: |
#74655 2015-05-31 12:51 |
The question is: how should I make one?
Added 19 minutes later: *LINK* How about this (if anyone does not have a suggestion on how a nuclear reactor looks like)? Added 36 minutes later: *LINK* I found this (the first picture from above) but dunno which part should resemble what in this picture. Could this work? Example (how I imagine it could work): -block = base (for the entire structure) -crankshaft = turbine (connected to generator) -connecting rods = steam generator -piston = pressurizer -cylinder head(s) = reactor vessel -camshafts (any equivalent part) = control rods (intake for the water part, but the exhaust is for the heated part) -intake manifold = condenser? -fuel = water supply/other suggestion on what? -flywheel/clutch = still remain as usual (mounts onto the turbine to deliver the power made towards the transmission) -transmission = still remain as usual (mounts onto the base for the structure to deliver the power made towards the wheels) -exhaust = any equivalent part, if that is even needed? -alternator = any equivalent part? -drive belt (for cam/crankshaft) = any equivalent part? -performance parts (turbos?) = any equivalent part? -NOS/N20 = any equivalent part?/if the equivalent for intake manifold is being made If you have ideas for how this can be improved, go ahead. This list is only a speculation on what is the best match for each part at the engine itself. NOTE: Remember that the list is far from complete and further on ideas will be needed for this. This post was edited by PXRZ (2015-05-31 13:49, ago) |
|
"Probably lol. Also that sentence goes for their logic: "if not released, must be on VK"." - Coprone "Sometimes i wonder if LocomanUSA is your relative, or even the same person..." - Bigg Boss93 "PXRZ: Lord of the Links" - Facepalm |