#Bigg Boss93 :
It's a cfg work;
> open the cfg of any cylinder head that supports those webers
> open the cfg of the other cylinder head and of the weber
> copy the attach/compatible slot from the first cfg to the second
It should work straight away, if not, you will have to set the second head's typeID on weber's slot.. i would post an example but i'm writing from phone.
I was reading the cfg's and i concluded the following: attach takes the ID of the part who want to join to the part of these cfg. For example, cylinder heads dont join to intake, the intake join to cylinder head, the cylinder head join to block, etc.
I put attach line with the cylinder head ID in the intake4carb.cfg, and compatible line with intake4carb ID in the cylinder head cfg, but donts works. All cylinder heads cfg that support intake4carb dont have ID's or any relation to intake4carb.cfg
Here are the cfg files edited
# Vehicle importer wizard generated part configuration file #
# resource ID of this part: 0x00000109
# resource alias of this part: "DS_LGT_intake4carb"
# Vehicle importer wizard generated part configuration file #
# resource ID of this part: 0x000010E9
# resource alias of this part: "Ishima_WR_head_cylinder_head"
