Author | Message |
hitman3695
Posts: 557
Location: Australia Occupation: hitman3695 Age: 109 V$: |
#1 2013-05-24 13:57 |
I downloaded an Acura Integra from somewhere and when I install the butterfly door (Door 2) I can't put the door panel on. It only workd on the normal door. I've looked in the CFG's and they both seem to be the same.
Please help so I can put the panel on |
|
Low is the way to go! |
|
robban_9000
Posts: 355
Location: Sweden Occupation: robban_9000 Age: 33 V$: |
#2 2013-05-24 16:33 |
Then u need to edit the door panel cfg
|
|
May God have mercy upon my enemies, because i wont.
|
|
RedCarDriver
Posts: 1211
Location: United States Arizona Occupation: it's complicated... more complicated than my relationships Age: 30 V$: 86310 |
#3 2013-05-24 21:52 |
There's two ways to do this:
1. Change the door panel CFG, as Robban suggested. 2. Make the second door use the same attachments as the first one. Do this in the CFG of the second door: slot -0.002 -0.115 0.007 0.000 0.000 0.000 25 ; FL_window...where 0x00000115 is the ID of the first door, and 25 is the slot in the first door being referenced. (See the chassis CFG for any chassis other than the "basic" one.) I hope this helps! |
|
|
|
hitman3695
Posts: 557
Location: Australia Occupation: hitman3695 Age: 109 V$: |
#4 2013-05-25 10:24 |
# Harrison15 : There's two ways to do this:Thanks you so much. With the driver door only the standard black panel and the green panel work but not the red and blue panels and the passenger door I managed to get all panels to work I just don't know why driver door is having trouble Added 2 minutes later: It's ok I got it to work Thanks again This post was edited by hitman3695 (2013-05-25 10:47, ago) |
|
Low is the way to go! |